flexible wood panel boards (tambour boards) with fluted half round sticks design for curved reception desk or bar front and curved wall and pole decoration

2024-02-10

Flexible wood panel boards (tambour boards) with fluted half round wood sticks design for curved reception desk or bar front and curved wall, pole decoration and office curved partition usages

Data sheet

Flexible fluted Half-Round Solid wood or MDF Wood sticks Tambour Panel Board

Wood kinds:   Solid Red Oak, MDF board

Size:   4 feet X 8 feet (1200 mm x 2400 mm)

Height:   6 mm

Half round stick:  18 mm width

Backing:  ECO resin reinforced non-woven fabric backing

Origin:    Made in Taiwan

Wood Veneer top flexible grooved wood slats tambour panel board

Wood kinds:   Oak, Maple, Cherry, and MDF board

Size:  4 feet X 8 feet (1200 mm x 2400 mm)

Thickness:  3 mm

flat slat by V-grooved:   13 mm width

Structure  Top Layer Wood veneer Middle Layer MDF board Bottom Layer ECO resin reinforced non-woven fabric backing or kraft paper

Usages:  Interior pole wraps and column covering, wood wall paneling, ceiling, furniture surface covers, flooring, wainscoting

Origin   Made in Taiwan

Use flexible wood panel boards (tambour boards) with fluted half round wood sticks design for curved reception desk or bar front, curved wall and pole decoration will be faster and easier by DIY. Also could get more free designs by your own. For your reference, the information on building a bar front is as below.

First- you need to measure the size of the bar front to be covered.

Second- according to the measured size you can trimmed with fine tooth saw or cut length-wise with utility knife.

Third- you can glue on the back of the board and paste flexible wood panel boards (tambour boards) with fluted half round wood sticks design on the bar front.

In the past, this product was half-round solid wooden strips one by one hand-made spliced together. It is not only time-consuming but also costly.

The long and thin wood strips tend twist, shift and slide during/after cut or milled. It may cause a problem of prone to inconsistencies in alignment spacing and parallelism of the strips.

Now, our flexible wood panel boards (tambour boards) with fluted half round wood sticks design is in full sheet 4’ (width) x 8’ (height).

The key point is our full sheet flexible wood panel boards (tambour boards) with fluted half round wood sticks design is cheaper than the old product with strips one by one.

It not only can be used on bar fronts but also can be used on walls, partitions, wainscoting, pole/

Flexible Half-Round MDF Panel Board is used for interior wood panel, wall panel, wood wrap and basement post/pole/column cover & wrap by DIY.

column wraps, drawer fronts and tambour doors.

Please refer to our flexible wood panel boards (tambour boards) with fluted half round sticks design Code No. CY300-02 & CY300-01N